Lenze E84Dxxxx User Manual
Ä.cwkä, 8400 protec l-force communication
Table of contents
Document Outline
- 8400 protec - PROFINET
- Contents
- 1 About this documentation
- 2 General information
- 3 Technical data
- 4 Installation
- 5 Commissioning
- 6 Data transfer
- 7 Process data transfer
- 8 Parameter data transfer
- 8.1 Addressing of the parameter data
- 8.2 DP-V0 parameter data channel (DRIVECOM profile)
- 8.3 DP-V1 parameter data channel (PROFIdrive profile)
- 8.4 Consistent parameter data
- 9 PROFIsafe
- 10 Monitorings
- 11 Diagnostics
- 12 Error messages
- 12.1 Short overview (A-Z) of the PROFIBUS-error messages
- 12.2 Possible causes and remedies
- Connection to 8400 standard device lost [0x01bc3100]
- Memory: No access [0x01bc5531]
- Memory: Read error [0x01bc5532]
- Memory: Write error [0x01bc5533]
- Restart after watchdog reset [0x01bc6010]
- Internal error [0x01bc6011]
- Internal error [0x01bc6100]
- Internal error [0x01bc6101]
- Internal error [0x01bc6110]
- Invalid parameter set [0x01bc641f]
- Error: Lenze settings loaded [0x01bc6420]
- Safety communication timeout [0x01bc6610]
- Safety parameter timeout [0x01bc6611]
- Safety Init error [0x01bc6612]
- Profibus watchdog: Monitoring time expired [0x01bc8130]
- Profibus: "Data_Exchange" status exited [0x01bc8131]
- Profibus watchdog: DP-V1 MSC2 monitoring time exceeded [0x01bc8132]
- 13 Parameter reference
- 13.1 Parameters relevant for the communication
- C13850 | All words to master
- C13851 | All words from master
- C13852 | All words to standard device
- C13853 | All words from standard device
- C13860 | Settings
- C13861 | Bus status
- C13862 | Bus counter
- C13863 | Baud rate
- C13864 | Active station address
- C13865 | Display: Last PRM data
- C13866 | Display: Last CFG data
- C13867 | Display: Last diagnostic data
- C13880 | Reaction on communication failure
- C13881 | Monit. time: Data exchange
- C13882 | Monitoring time: Watchdog
- C13885 | Delete process data
- C13886 | Set ext. diagnostic bit by
- C13899 | Station address
- C13900 | Firmware product type
- C13901 | Firmware compilation date
- C13902 | Firmware version
- C13920 | Display: DIP switch setting
- 13.2 Table of attributes
- 13.3 Implemented PROFIdrive objects (DP-V1)
- 13.1 Parameters relevant for the communication
- 14 DIP switch positions for setting the station address
- 15 Index
- Contents