Leica Biosystems IPC - Manual (Page 61)

59 Leica IP C
Transporting the printer
If the printer is to be shipped, the storage instructions described above
are to be carried out completely. Then, additionally make the following
preparations:
• Open the hood (4 in Fig. 36) of the printer and loosen the screw of the
flash cover.
• Then take out the flash bulb. For more information, refer to Chap. 4.6 of
this manual
• Close the flash cover and the hood.
• Use original packaging and securely screw the printer to the baseplate
(see unpacking instructions).
• Reinsert the transport anchor (27) (see Fig. 16 ) and secure the hood with
adhesive tape.
• Make sure that the instrument is only transported upright.
• Likewise, clean the removed location plate (70)
with the sealing lip with (clean) alcohol and a
cleaning swab (89) ( Fig. 66 ).
• The sealing lip (71) must be completely free of
ink residue. Check the sealing lip for damage.
Do not reuse a replacement plate with a dam-
aged sealing lip.
• Clean the instrument completely, as described
in this chapter.
Instructions for storage (continued)
Fig. 66
70
71
89
6. Cleaning and Maintenance