Landoll 2410 Weatherproofer I - Manual (Page 21)

ASSEMBLY INSTRUCTIONS
3-3
Weatherproofer I Frame
Assembly
IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.

WARNING
1. Place both frame halves on stands approximately 36”
high. The assembly area should be a large level area
of sufficient size to accommodate the
Weatherproofer I when fully assembled (See
Figure 3-1.)
2. Bolt frame halves together using 3/4-10 x 2-1/4 hex
head cap screws and hex lock nuts in the front and
rear plates. Bolt center frame halves together using
frame joint plate, 3/4-10 x 6 hex head cap screws,
and hex lock nuts. Leave all screws loose.
3. Level the frame halves.
4. Tighten all hardware to the recommended torques
shown in Table 2-1.
Do not attempt to lift heavy parts (such as the
frame, disc gangs, wheel lift, and pull hitch)
manually. Use a hoist or a forklift to move these
parts into position.