Landoll SCP-2 Subsoil Chisel Plow - Manual (Page 8)

1298rev401 6K007
Plate
Machine Bolt,
3/4-10 NC x 7 1/2”
Shank
Assembly
R.H. Angle
L.H. Angle
Capscrew,
5/8-11 NC x 3 3/4”
Capscrew,
3/4-10 NC x 3 31/2”
Frame
Tube
Lock Nut,
5/8-11 NC
Lock Nut,
3/4-10 NC
Hex Nut,
3/4-10 NC
Lockwasher, 3/4”
Figure 3
TIGHTEN THESE BOLTS UNTILTHE ANGLES ARE
JUST SNUG AGAINST THE SHANK. THE BOLTS
SHOULD BE EASILY
TURNED WITH A WRENCH
ON THE BOLT HEAD WHEN
CORRECTLY TIGHTENED.
OVER TIGHTENING
THESE BOLTS
WILL NOT
ALLOW THE SHANK
TO PIVOT AND SHEAR
THE FRONT BOLT
IF AN OBSTRUCTION
IS HIT.
Page 6
SET-UP INSTRUCTIONS
Your Brillion Subsoil Chisel Plow is shipped to you in separate assemblies. Before assembling the unit,
separate the various bundles and open the box assembly, taking care not to lose any of the parts or hardware.
(Refer to repair parts section for relative location of parts.)
Block up the frame or mount it to the three point hitch on the tractor for the assembly of shanks.
Securely block machine when working on or under it to prevent injury in case of hydraulic
failure or inadvertent lowering by another person.
Assemble the shank(s), as shown in Figure 3
1. Assemble the angles to the frame. Right- and Lefthand angles are held to the underside of the frame tube
with a plate above it and fastened with 3/4” x 7 1/2” bolts, lockwashers, and nuts.
(The illustration shows a double-shank model.
In the single-shank model, the angles are
welded in place).
2. Assemble the shank between the mounting angles and install the
bolts through the angles, shanks and locknuts as shown, with two
5/8” x 3 3/4” long bolts at the front and a 3/4” x 3 1/2” bolt at
the rear.
The front bolt that is installed through the angles is designed
only to keep the angles from spreading if the front shank bolt
shears.
3. On the two shank model, adjust shanks to the desired spacing and
tighten the vertical clamping bolts.