Landoll SCP-2 Subsoil Chisel Plow - Manual (Page 6)

1298rev401 6K007
2
Figure 2A
1
1. 8J310 - Decal, “Caution” list
2. 2J430 - Decal, Reflective Red
3. 8K829 - Decal, Deep Till Caution
SAFETY WARNING SIGNS
The “WARNING” signs illustrated on this page are placed on the machine to warn of hazards.
The warnings found on the sign are for your personal safety and those around you. Their locations
on the machine are shown on the following page. OBSERVE THESE WARNINGS!
Keep these signs clean so they can be observed readily. Wash with soap and water or cleaning
solution as required.
Replace “WARNING” signs should they become damaged, painted over or if they are missing.
When replacing decals, clean the machine surface thoroughly using soap and water or cleaning
solution to remove all dirt and grease.
1. DO NOT LUBRICATE, ADJUST OR REPAIR WHEN MACHINE IS IN MOTION.
2. DO NOT TOW OR TRANSPORT FASTER THAN 15 MILES PER HOUR.
3. DO NOT RIDE OR ALLOW OTHERS TO RIDE ON THE MACHINE.
4. BLOCK UP ALL HYDRAULICALLY OR MECHANICALLY RAISED COMPONENTS TO
PREVENT UNINTENDED LOWERING, OR LOWER THE MACHINE TO THE GROUND
TO MAKE ADJUSTMENT OR REPAIRS WHEN NOT IN USE.
5. KEEP ALL PERSONS AWAY FROM MACHINE DURING HITCHING AND OPERATING.
6. SLOW DOWN BEFORE MAKING SHARP TURNS OR USING THE BRAKES.
DRIVE SLOWLY OVER ROUGH GROUND, SIDE HILLS, AND AROUND CURVES TO
AVOID TIPPING.
7. COMPLY WITH ALL LAWS WHEN TRANSPORTING THE MACHINE ON PUBLIC
ROADWAYS.
8. INSTRUCT ALL OPERATORS IN THE SAFE OPERATION OF THE MACHINE.
REVIEW THE OPERATOR’S MANUAL FOR CORRECT PROCEDURES.
9. BLOCK IMPLEMENT TO PREVENT MOVEMENT WHEN UNHITCHED FROM TRACTOR.
8J310
CAUTION
Page 4
SAFETY SUGGESTIONS
Investigation has shown that nearly one-third of all farm accidents are caused by careless use of
machinery. You can do your part in improving safety by observing the following suggestions. Insist
that all people working with you or for you abide by them.
1. Never turn corners at a high rate of speed.
2. Never work under the chisel plow unless it is securely blocked up and cannot be knocked off
the blocks.
3. Always take care in raising and lowering the chisel plow, and be certain that no one is in the
way.
4. Never allow passengers to ride on the chisel plow.
5. Display the Slow Moving Vehicle emblem when traveling on roads.
6. When traveling on the road at night, make sure that reflective decals and accessory warning
lights are mounted and visible on the machine. Local regulations should be checked first, and if
there are none, the chisel plow owner should take the initiative to make his machine noticeable
at night.
CAUTION
DEEP TILL OPERATION CAN DAMAGE
UNDERGROUND UTILITIES CAUSING
DANGEROUS CONDITIONS AND
DISRUPTING SERVICES. DETERMINE
THE DEPTH AND LOCATION OF BURIED
CABLES, PIPE LINES, AND DRAIN
TILES BEFORE OPERATION.
8K829
3
2-10-04