Landoll SCPH-33 Subsoil Chisel Plow - Manual (Page 8)

1001 7K299
Figure 3
NOTE:
TIGHTEN THESE BOLTS
UNTILTHE ANGLES ARE JUST
SNUG AGAINST THE SHANK.
THE BOLTS SHOULD BE
EASILY TURNED WITH A
WRENCH ON THE BOLT
HEAD WHEN CORRECTLY
TIGHTENED.
OVER TIGHTENING THESE
BOLTS WILL NOT ALLOW
THE SHANK TO PIVOT AND
SHEAR THE FRONT BOLT IF
AN OBSTRUCTION IS HIT.
Page 6
SET-UP INSTRUCTIONS
Your Brillion Subsoil Chisel Plow is shipped to you in separate assemblies. Before assembling the unit,
separate the various bundles and open the box assembly, taking care not to lose any of the parts or hardware.
(Refer to repair parts section for relative location of parts.)
Block up the frame or mount it to the three point hitch on the tractor for the assembly of shanks.
Securely block machine when working on or under it to prevent injury in case of hydraulic
failure or inadvertent lowering by another person.
Assemble the shanks, as shown in Figure 3
1. Assemble the angles to the frame. Right- and Left-hand angles are fastened to the underside of the
frame tube with with 3/4” U-bolts, lockwashers, and hex nuts, but do not tighten u-bolts completely at
this point.
2. Assemble the shank between the mounting angles and install the
bolts through the angles, shanks and lock nuts as shown, with two
5/8” x 3 3/4” long bolts at the front and a 3/4” x 3 1/2” bolt at
the rear.
3. Adjust shanks to the desired
spacing and tighten the u-bolts.
Shank
Assembly
R.H. Angle
L.H. Angle
U-bolt, 3/4-10 NC
x 5 3/4 Deep
Front
Frame Tube
Lock Nut,
5/8-11 NC
Hex Nut,
3/4-10 NC
Lockwasher,
3/4”
Bolt, 5/8-11NC
x 3 3/4”
Lock Nut,
3/4-10 NC
Rear
Frame Tube
U-bolt, 3/4-10 NC
x 5 3/4 Deep
Machine Bolt,
3/4-10 NC x 3 1/2”