Landoll LSS6 Landscape Grass Seeder - Manual (Page 24)

3-4 7K458
ASSEMBLY OF OPTIONAL EQUIPMENT
Acre Meter Kit 6K036 Installation
The Acre Meter Kit consists of four main parts; Acre
Meter Assembly, Pick-up Switch Bracket, Pick-up Switch,
and Magnet Wheel.
1. Drill 13/32” holes into seedbox at location shown.
See Figure 3-4.
2. Next, use 3/8-16 NC x 1” capscrews, lockwashers,
and nuts to attach the bracket which holds the acre
meter, as shown, onto the left front of the seedbox.
3. Mount the acre meter onto this bracket with #10-24 x
1” machine screws, lockwashers and nuts.
4. Run the wire from the bottom of the meter down the
side of the seed box and along its left side. Use
mounting bases to hold the wire in place. Run it
across the plate which attaches the seedbox to
endplate. Here, it will plug into the mating cable from
the pick-up.

WARNING
Figure 3-4: Acre Meter Installation (1 of 2)
Do not pressure clean with air or water.
MACHINE SCREW,
#10-24 x 1”
NUT, 3/8”
ACRE METER
ASSEMBLY
DRILL 13/32”
HOLES
LOCKWASHER, 3/8”
FRONT OF
SEEDER
#10
LOCKWASHER
NUT, #10-24
PICK-UP BOX
CABLE
ACRE METER
CABLE
MOUNTING
BASE
CAPSCREW,
3/8-16 NC x 1”