Landoll LSS6 Landscape Grass Seeder - Manual (Page 13)

OPERATION
2-3
Seed Rate Adjustment-Adjusting
the Box Slide
When properly adjusted, with the control handle set at
“6”. The holes in the slide should line up with the holes in
the box, See Figure 2-3. To make an adjustment, loosen
the control handle on the box, move the slide until the
holes line up. When the handle is moved to “0” the holes
in the box should be completely covered. See Figure 2-4.
If the holes are not covered, loosen the three bolts
holding the seedmeter casting and shift it slightly so that
the “0” mark is farther from the control handle. Retighten
the bolts. Move control handle to “0”. Holes in the box
should then be completely covered. See Figure 2-5.
Figure 2-3: Control Handle at “6”
Figure 2-4: Control Handle at “0”
Figure 2-5: Seedmeter Casting Bolts
If the holes are not covered
when set at 0, loosen these
three bolts holding the
seedmeter casting and shift
it slightly. Retigthen the bolts.