Landoll LSS6 Landscape Grass Seeder - Manual (Page 12)

2-2 7K458
OPERATION
Attaching to a Tractor
When hooking up seeders:
• Attach tractor.
• Remove klik pin, pull parking pin into outer position,
• Replace klik pin.
When unhooking seeder:
• Remove klik pin, push in parking pin,
• Replace klik pin.
• Disconnect tractor.
On LSS6, skid steer models, there is a parking pin
located on each side of the frame. In addition, a quick
attach frame attaches to the rear frame tube of the
seeder by means of two pins and klik pins. See
Figure 2-2.
Figure 2-2: Attaching to a Tractor
PARKING
PIN
KLIK
PIN
Use this hole when
(Use this hole when
connected to tractor)
Parking Pin
(each side)
Quick
Attach
Frame
Pin,
(2) Klik pins
Disconnected from the tractor