KD Scientific Allegro Peristaltic Pump Series - Manual (Page 59)

59 K
D
S
A
lle
g
ro
P
e
ri
s
ta
lt
ic
P
u
m
p
S
y
s
te
m
U
s
e
r’s
M
a
n
u
a
l
phone
508.429.6809
fax
508.893.0160
e-mail
[email protected]
web
www.kdscientific.com
KD Scientific Allegro Peristaltic Pump System User’s Manual
Publication 5613-004-REV-A
Operating the KDS Allegro Peristaltic Pump System
VERSION
Displays the full version string.
Command format:
version
Query response:
[##:]Firmware: v#.#.#
[##:]Pump address: #
[##:]Serial number: C ######
[##:]Device ID: ########
[##]
Run commands
FRUN
Runs the pump in the forward direction. Configuration Run
screen mode only.
Command format:
frun
CHGDIR
Runs the pump in the opposite direction. Configuration
Run screen only.
Command format:
chgdir
RUN
Simulates a key press of the run button located in the lower
right corner of the screen.
Command format:
run
STOP / STP
Stops the pump.
Command formats:
stop
stp
RRUN
Runs the pump in the CCW direction. Configuration Run
screen mode only.
Command format:
rrun
Rate commands
CRATE
Displays the current rate that the motor is running at. A
valid response is returned only in dynamic situations (if
the motor is running). Configuration Run screen mode
only.
Command format:
crate
Query response:
[##:]forward at # xl/xxx
[##]
or:
[##:]reverse at # xl/xxx
[##]
DIAMETER
Sets or displays the tubing diameter in mm. Configuration
Run screen mode only.
Command format:
diameter [{tubing diameter}]
Query response:
[##:]#.#### mm
[##]
FRAMP
Sets or displays the dispensing (forward direction) rates
while ramping. Configuration Run screen mode only.
Command format:
framp [{start rate} {start units} {end rate} {end units}
{ramp time in seconds}]
Query response:
[##:]Ramp not set up.
[##]
or:
[##:]# xl/xxx to xl/xxx in # seconds
[##]