KD Scientific Allegro Peristaltic Pump Series User Manual
Page 36
36
K
D
S
A
lle
g
ro
P
e
ri
s
ta
lt
ic
P
u
m
p
S
y
s
te
m
U
s
e
r’s
M
a
n
u
a
l
phone
508.429.6809
fax
508.893.0160
web
www.kdscientific.com
KD Scientific Allegro Peristaltic Pump System User’s Manual
Publication 5613-004-REV-A
Operating the KDS Allegro Peristaltic Pump System
Setting A Delay
You can set the KDS Allegro Peristaltic Pump System to
run after a delay. This delayed run function allows you to
set up all the parameters for operation, then have the
pump start unattended after a specified amount of time.
SETTING A DEL AY FOR PROGRAM OPERATION:
1.
From the program configuration screen, choose the
Set Delay button to enter the Set Delay Screen.
2. Enter the desired Time using the keypad.
3. If the Units of your Time are not correct for your
application, select the Units button to toggle
between sec (seconds) and hh:mm:ss
(hours:minutes:seconds). To use the hh:mm:ss
option, enter your time value in hours, minutes,
and seconds, separating each value with a colon.
You can enter a value up to 99:99:99.
4. When the desired values are entered, choose the
Accept button to save your changes and return to
the Program Configuration screen. When a Time
Delay value is active, the Time Delay Parameters
button is displayed in Red on the screen to alert
the user that a delay has been set.
5.
Press the Run button to activate the Delay.
Set Delay Time screen
Quick Start run screen with a Time Delay Set