Brother FAX-1820C - Manual (Page 80)

6 - 9 SETUP SEND
Dual Access (Not available for colour faxes)
You can dial a number, and begin scanning the fax into memory—
even when the machine is sending from memory or receiving faxes.
The LCD shows the new job number and available memory.
Real Time Transmission
When you are sending a fax, the machine will scan the documents
into the memory before sending. Then, as soon as the phone line is
free, the machine will start dialling and sending.
If the memory becomes full, the machine will send the document in
real time (even if
Real Time TX is set to Off ).
Sometimes, you may want to send an important document
immediately, without waiting for memory transmission. You can set
Real Time TX to On for all documents or for the next fax only.
1
If it is not illuminated in green, press ( Fax ).
2
Load your document. (See Load documents on page 2-1.)
3
Press Menu/Set , 2 , 2 , 5 .
Your machine normally uses Dual Access. However, to send a
colour fax, the machine will send the original in real time (even
if
Real Time TX is Off ).
The number of pages you can scan into the memory will vary
depending on the data that is printed on them.
If you get an Out of Memory message while scanning the first
page of a fax, press Stop/Exit to cancel scanning. If you get an
Out of Memory message while scanning a subsequent page,
you can press Mono Start to send the pages scanned so far,
or press Stop/Exit to cancel the operation.
5.Real Time TX