JUMO PCA3000 PC Evaluation Software - Manual (Page 47)

47
9 Evaluation - Table area
Y-axis type The axis type for a channel can be selected here. Available options are:
- main Y-axis
Please note that always only one channel can have a main Y-axis.
The Y-axis can be found at the left edge of the screen.
- auxiliary Y-axis
The auxiliary Y-axes are to the right of the main Y-axis. Scaling of the data
is adapted to the main Y axis.
- no Y-axis
No Y-axis is displayed for the selected channel.
9.2.2 Displays (cannot be altered directly)
Ratio
of displayed
measurements
... The current display factor is shown here. The factor changes if the
measurements are zoomed.
Example: Factor = 1:3 --> every third measurement is displayed.
The parameter “Maximum number of measurements displayed per channel”
will affect the factor.
v See “Maximum number of measurements displayed per channel” on
page 40.
Display for
channel unit Shows the unit of the channel that has been configured on the device.
Channel name Shows the channel name that has been configured on the device.
Group name Shows the group name that has been configured on the device.
Scaling start Shows the scaling start that has been configured on the device.
Scaling end Shows the scaling start that has been configured on the device.
Channel
description Shows the channel description that has been configured on the device.