JUMO PCA3000 PC Evaluation Software - Manual (Page 40)

8 Evaluation - Graphics area
40
The difference between the two view modes will only become obvious if there
is a vast amount of data to be processed.
Maximum number of measurements displayed per channel
You can set the number of the measurements to be displayed per channel by
entering a number (from 10 to 10000) here. The higher the number, the more
measurements will be shown in the graphics. The lower the number, the less
measurements will be shown.
Properties !
Display all
measurements
Normally, only every nth measured value is displayed (depending on the zoom
factor). This also applies to the print preview (page view) and the printout. You
can force the display or printout of all measurements by means of the
“Printout” and “Print preview” buttons.
Save diagram
as bitmap This function saves the current contents of the graphics area as a picture in
bitmap format.
Save diagram
as Jpeg This function saves the current contents of the graphics area as a picture in
JPEG format.
H
Caution: If the selected number of measurements is too small, the
graphics will be displayed faster, but you will have to partially
guess the curve profile for the actual measured values.