JUMO 705030 mTRON T - Digital Input/Output Module Operating Manual - Manual (Page 36)

6 Configuration
36
6.2 NV connecting list
The NV connecting list is used to link external inputs (NV_...) of the digital input/output module
to signals from other modules via the system bus.
A comprehensive list with the module signals is included in the following chapter:

Chapter 6.2.1 "Digital signals (overview)", page 37
Further information about the signals can be found in the operating manual for the relevant
module.
Replacement values are available in the event that these signals are not available (connection
to base unit interrupted or system in "Stop" state).

Chapter 6.2.2 "Replacement values (overview)", page 42
Setup dialog
Parameters
NOTE!
There is no NV connecting list in the input/output module configuration menu on the multi-
function panel. Instead, a central NV connecting list is available in the configuration menu of
the base unit (CPU).
Parameters Selection/settings Description
Digital signal /
Value Select input to be connected. List of external inputs of the module
If a connection has already been config-
ured, the module and its signal are dis-
played in the "Value" column.
...\NV_SR01
(Example) This is the previously selected external input.
Select the module and – in the selector
next to it on the right – the signal to con-
nect to the external input. List of modules in the system and the
relevant signals