JULABO SC 2500w Eco-Series Recirculating Coolers - Manual (Page 43)

Recirculating Cooler
43
in commands: Asking for parameters or temperature values to be displayed.
Command Parameter Response of circulator
version None Number of software version (V X.xx)
status none Status message, error message (see page 44 )
in_pv_00 none Actual bath temperature.
in_pv_01 none Heating power being used (%).
in_pv_03 none Temperature value registered by the safety sensor.
in_pv_04 none Setpoint temperature („SafeTemp“) of the excess
temperature protection
in_sp_00 none Working temperature „t 1“
in_sp_03 none High temperature warning limit „t High“
in_sp_04 none Low temperature warning limit „t Low“
in_sp_07 none Pump pressure stage
in_par_00 none Temperature difference between working sensor and safety
sensor
in_par_01 none Te - Time constant of the external bath.
in_par_02 none Si - Internal slope
in_par_06 none Xp control parameter of the internal controller.
in_par_07 none Tn control parameter of the internal controller.
in_par_08 none Tv control parameter of the internal controller.
in_mode_05 none Circulator in Stop/Start condition:
0 = Stop
1 = Start