Intelix DIGI-44B - Manual (Page 13)

DIGI-44B Installation Guide
6. Turn the power to the DIGI-44B on – after 5 seconds, the DIGI-44B will
send some lines of information you can see in the communications
window. This confirms that you are communicating properly.
7. In the “Send Sequences” window, press the Set IP (Use
Wildcards) button.
8. Type the desired IP address in 3 byte sequences,
pressing the Enter key on your keyboard after each
sequence.
9. Verify that the IP address changed
in the communication window. .
*Note – it can take 5-10 seconds
for the unit to report back the
confirmed change.
DHCP IP assignment via RS232
You can change the IP mode to DHCP using RS232
1. Download Docklight and the DIGI-44B from the Intelix website.
2. Connect the included USB -> RS232 adapter to an open USB port on your computer, or if you have
a serial port, connect a straight through serial cable. When using the
USB->RS232 adapter for the first time, device drivers should be automatically installed.
3. Open the Docklight Configuration File.
13