INFICON SKY CDGxxxD (EtherCAT) - Manual (Page 14)

14
tira68e1 (2013-05) CDGxxxD.cp
Index SI DataType NV Access PM Name
2800 0x01 BYTE RW Safe State
0x02 REAL RW Safe Value
0x03 BOOL RW Alarm Enable
0x04 BOOL RW Warning Enable
0x05 REAL RW Alarm Trip Point High
0x06 REAL RW Alarm Trip Point Low
0x07 REAL RW Alarm Hysteresis
0x08 REAL RW Warning Trip Point High
0x09 REAL RW Warning Trip Point Low
0x0A REAL RW Warning Hysteresis
0x0B BYTE RW Filter
Specifies the behavior for the value for States other than Valid.
Safe State
0
1
2
3 Zero
Full Scale
Hold last value
Use safe value
Safe Value: The value to be used for Safe State = Safe Value.
Alarm Enable: Enables the setting of the Alarm Status Bits.
Warning Enable: Enables the setting of the Warning Status Bits.
Alarm Trip Point High: Determines the value above which an Alarm Condition will
occur.
Alarm Trip Point Low: Determines the value below which an Alarm Condition will
occur.
Alarm Hysteresis: Determines the amount by which the value must recover to clear
an Alarm Condition.
Warning Trip Point High: Determines the value above which a Waning Condition
will occur.
Warning Trip Point Low: Determines the value below which a Waning Condition will
occur.
Warning Hysteresis: Determines the amount by which the value must recover to
clear a Warning Condition.
Filter
0
1
2 Dynamic (factory default)
Fast
Slow
4.3.3 Manufacturer
Configuration Module 1
Subindex 0x01
Subindex 0x02
Subindex 0x03
Subindex 0x04
Subindex 0x05
Subindex 0x06
Subindex 0x07
Subindex 0x08
Subindex 0x09
Subindex 0x0A
Subindex 0x0B