INFICON VGC403 Three-Channel Measurement and Control Unit - Manual (Page 34)

34
tinb07e1-e 2011-07 Vacuum Gauge Controller
6.3 Mnemonics
6.3.1 Overview
Tab. 6-3 Mnemonics
Mnemonic Significance
AOM Analog output mode. Characteristic
curve of the recorder output.
BAU Baud rate. Transfer rate of the
RS232C interface.
COM Continuous mode. Continuous
transmission of measurements to
the serial interface.
COR Correction factor.
DCD Display control digits. Number of
digits shown in the display.
DGS Degas.
ERA Error relay allocation.
ERR Error status.
EUM Switch the emmision.
FIL Filter. Measurement filter.
FUM Select the filament.
FSR Full scale range. Full scale range of
linear sensors (CDG).
GAS Gas type correction.
HVC High vacuum circuit on/off. Switch
the high vacuum circuit of sensors
on/off.
ITR Read a data string from the
BPG/BCG/HPG/CDGxxxD sensor.
LOC Parameter setup lock.
OFC Offset correction. Offset correction
function for linear sensors (CDG).
OFD Offset display. Offset correction val-
ues for linear sensors (CDG).
PNR Program number. Firmware version
number.
PR1 Pressure sensor 1. Pressure read-
ing of sensor 1.
PR2 Pressure sensor 2. Pressure read-
ing of sensor 2.
PR3 Pressure sensor 3. Pressure read-
ing of sensor 3.
PRE Pirani range extension.
PRX Pressure sensors. Pressure read-
ings of all sensors.
RES Reset. Reset the serial interface.
SAV Save parameters to EEPROM.
SC1 Sensor 1 control.
SC2 Sensor 2 control.
SC3 Sensor 3 control.
SP1 Setpoint 1. Switching function 1.
… …
SP6 Setpoint 6. Switching function 6.
SPS Setpoint status. Switching function
status.
TAD Test A/D converter. Test the A/D
converter.
TDI Test display. Test the display.
TEE Test EEPROM. Test the EEPROM.
TEP Test EPROM. Test the EPROM.
TID Transmitter identification. Sensor
identification.
TIO Test I/O. Test the relays.
TKB Test keyboard. Test the keyboard.
TLC Torr lock.
TRA Test RAM. Test the RAM.
TRS Test RS232C interface. Test the
RS232C interface.
UNI Unit of measurement.
WDT Watchdog control.
Mnemonic Significance