INFICON VGC403 Three-Channel Measurement and Control Unit - Manual (Page 19)

tinb07e1-e 2011-07 Vacuum Gauge Controller
19
4.5 Parameter mode
4.5.1 Selection
Pressing the PARA button switches from the measure-
ment mode to the parameter mode. The PARA indicator
is illuminated.
When the unit is set to the parameter mode, it will auto-
matically return to the measurement mode if no button is
pressed for 10 seconds. The PARA indicator is dark.
4.5.2 Parameter groups
The parameter mode gives you access to various param-
eters. You can check the parameter settings or modify
them using the arrow buttons. This allows you to config-
ure the Vacuum Gauge Controller.
Tab. 4-3, 19 shows all available parameters.
Tab. 4-3 Parameter groups and their parameters
The available parameters are subdivided into the follow-
ing parameter groups:
Switching function parameters (PArA SP)
These parameters are used to assign pressure depen-
dent switching functions to the channels. The switching
points 5 and 6 are only available in the VGC403. See
Chapter 5.1 Switching function parameters (PArA SP),
21.
Sensor parameters (PArA SEn)
These parameters concern the sensor on the currently
selected channel only. There is an individual set of
parameters for each channel. See Chapter 5.2 Sensor
parameters (PArA SEn), 23.
General parameters (PArA GEn)
These parameters are used for general configuration of
the unit. The parameters affect all channels. See
Chapter 5.3 General parameters (PArA GEn), 27.
Test parameters (PArA tESt)
This parameter group is used to check individual system
functions. The parameter group is not required during
normal operation. For this reason it must be accessed in
a special way. See Chapter 5.4 Test parameters (PArA
tESt), 29.
Parameter
group
Parameter
PArA
SP
SP1-L
SP1-H
SP2-L
SP2-H
SP3-L
SP3-H
SP4-L
SP4-H
SP5-L
SP5-H
SP6-L
SP6-H
PArA
SEn
FiLt
GAS
FS
oFS
dEGAS
S-on
S-oFF
EMi
FiL
PrE
PArA
GEn
unit
bAud
diGit
dEF
Ao
Err-r
PArA
tESt
Pnr
dt-C
tr-L
LoC
rA-t
EP-t
EE-t
di-t
Ad-S
Ad-i
CALib
io-t
rS-t
Parameter
group
Parameter