INFICON MPI-16 Crucible Indexer - Manual (Page 25)

MPI-16 & MPI-16H POCKET INDEXERS
Setup and Installation 3-7
1 Blink – Switch Out Of Range Error ’
Conflict:
• The Number of Positions switch must be set on a valid, marked setting.
• The Rotation Mode switch must be set on a valid, marked setting.
2 Blinks – Circular Pocket Error ’’
Condition:
• Circular Mode is set (Number of Positions = “Cir.”).
Conflicts:
• The Rotation Mode switch must be set to either CW or CCW.
• Banana Pocket #1 Length must be set to 0
• Banana Pocket #2 Start Position must be set to 0, and
• Banana Pocket #2 Length must be set to 0.
* Note: Setting Banana Pocket #1 Length equal to Number of Pockets also specifies a
Circular Pocket, but it is recommended that you use Number of Pockets = “Cir.”
3 Blinks – No Banana Pockets Error ’’’
Condition:
• No Banana Pockets (Banana Pocket #1 Length = 0)
Conflicts:
• Banana Pocket #2 Start Position must be set to 0, and
• Banana Pocket #2 Length must be set to 0.
4 Blinks – One Banana Pocket Error ’’’’
Conflicts:
• Banana Pocket #1 Length cannot be set to 1.
• Banana Pocket #1 Length must be less than Number of Positions.
5 Blinks – No Second Banana Pocket Error ’’’’’
Condition:
• No Second Banana Pocket (Banana Pocket #2 Start Position = 0)
Conflict:
• Banana Pocket #2 Length must be set to 0.
6 Blinks – Two Banana Pockets Error ’’’’’’
Condition:
• Banana Pocket #2 Start Position > 0
Conflicts:
• Banana Pocket #2 Length cannot be set to 0.
• Banana Pocket #2 Length cannot be set to 1. A pocket occupying a single position
is not considered a Banana Pocket.
• Banana Pocket #2 Start Position must be greater than or equal to (Banana Pocket
#1 Length + 1).
• Banana Pocket #2 Start Position + Banana Pocket #2 Length must be less than or
equal to (Number of Positions + 1).
• Banana Pocket #1 Length + Banana Pocket #2 Length must be less than or equal
to Number of Positions.
Table 3-1 Configuration Errors