INFICON CI-100 Crucible Indexer - Manual (Page 23)

2 - 7
IP
N 07
4-
54
4-
P1
B
CI-100 Crucible Indexer Operating Manual
There are two possible Pocket Select Bit decodings as shown below:
Switch #7 Off (down) Switch #7 On (up)
Pocket Bit0 Bit1 Bit2 Bit0 Bit1 Bit2
1 Hi Hi Hi Lo Hi Hi
2 Lo Hi Hi Hi Lo Hi
3 Hi Lo Hi Lo Lo Hi
4 Lo Lo Hi Hi Hi Lo
5 Hi Hi Lo Lo Hi Lo
6 Lo Hi Lo Hi Lo Lo
7 Hi Lo Lo Lo Lo Lo
8 Lo Lo Lo Hi Hi Hi
When the BCD I/O is used to select/operate custom banana configurations,
operation of the Bit 0 to Bit 2 inputs and interlock are as follows.
1 Short the Interlock pin to ground to stop movement.
2 Select the desired pocket on BCD bits 0 to 2 to move to a new pocket.
3 Release Interlock to start sweeping at the selected pocket.
4 Short interlock to stop sweeping. Release interlock to start sweeping.