INCRA Miter Express - Manual (Page 2)

FIG. 1 Miter Express Components
A Small Miter Express Panel w/rounded corners
B Small Miter Express Panel w/square corners
C Large Miter Express Panel
D Hold Down Clamp
E Hardware Pack C-15 (Outboard Fence Support and
Fasteners)
F Hardware Pack C-13 (Panel Assembly Fasteners and
Hex Keys)
G Hardware Pack C-14 (T-Slot Retainers and Cam
Screws)
H Utility Plate
I Panel Connector
J Aluminum Miter Bar
K UHMW Glide Strips
Miter Express Owner’s Manual (not pictured)
ParTs lIsT ParTs lIsT
Carefully Unpack Components
After carefully unpacking all components, check the contents against the photo in Fig. 1 and parts list below.
asseMBlY asseMBlY
FIG. 2 Left of blade
A C
B
E
I
F
H
J
K
D
G
FIG. 3 Right of blade
Left or Right Miter Slot
Before beginning the panel assembly, you’ll want to first determine on which side of the blade you want the miter
sled. Typically, if your blade tilts to the right, you’ll want the miter sled to the left of the blade (Left Miter Slot), Fig. 2.
If your blade tilts left, then you’ll want the sled on the right side of the blade (Right Miter Slot), Fig. 3.
1
2