HMC Electronics ASG-SD2500-10FX-SY X-PAQ Precision Fastening System - Manual (Page 8)

Tool Installation:
Connect the tool cable to the connector on the bottom of the controller by
tabs in the large cable connector. Align these tabs and insert the cable to the cont
twist-lock on the cable connector clockwise until it
Note: To remove the cable from the controller, rotate the twist
counter-clockwise until it pops free, and then remove the cable
Obtain the ASG-SD2500 tool and identify the slot on the screwdriver connector into which the
screwdriver cable plugs. Find the red dot on the small end of the cable, and align it to the slot in the
screwdriver connector. Insert the cable to the tool firmly until it
Note: To remove the cable from the tool, slide the grip of the cable connector away from the
tool, then pull the cable out of the tool.
Connect the controller to the power source and power
Do not depress either the push to start spindle or the throttle lever during controller power
doing so will result in a ToolEE Error which will require a reboot of the controller.
Twist-lock
Alignment
Tabs
Page 8
Connect the tool cable to the connector on the bottom of the controller by identifying
tabs in the large cable connector. Align these tabs and insert the cable to the controller, then rotate the
lock on the cable connector clockwise until it clicks into place.
: To remove the cable from the controller, rotate the twist-lock on the cable connector
clockwise until it pops free, and then remove the cable from the controller.
SD2500 tool and identify the slot on the screwdriver connector into which the
screwdriver cable plugs. Find the red dot on the small end of the cable, and align it to the slot in the
cable to the tool firmly until it clicks into place.
: To remove the cable from the tool, slide the grip of the cable connector away from the
tool, then pull the cable out of the tool.
Connect the controller to the power source and power-up the controller.
Do not depress either the push to start spindle or the throttle lever during controller power
doing so will result in a ToolEE Error which will require a reboot of the controller.
Grip
Dot
the alignment
roller, then rotate the
lock on the cable connector
SD2500 tool and identify the slot on the screwdriver connector into which the
screwdriver cable plugs. Find the red dot on the small end of the cable, and align it to the slot in the
: To remove the cable from the tool, slide the grip of the cable connector away from the
Do not depress either the push to start spindle or the throttle lever during controller power-up,
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
http://www.hmcelectronics.com
(800) 482-4440