HMC Electronics ASG-SD2500-10FX-SY X-PAQ Precision Fastening System - Manual (Page 23)

Page 23
function. Only activating the reverse input will merely set the tool to reverse, it will still
require the start signal to run.
• REMOTE RESET: From the ‘Run Tool’ Screen:
o Tap the ‘Setup’ Button
o Make sure the task shown at the top is the one to be programmed.
o Tap the ‘Inputs’ Button
o Tap the arrow button on the bottom next to ‘Setup Bolt(s)’ so that ‘Setup Misc’ appears.
Select the ‘Remote Reset’ button on the left side of the screen. You should now see a column of
buttons appear in the chart next to each input number. You may now select which input you
want to use to reset the tool by tapping the ‘Ignore’ button to the right of that input. This will
toggle between ‘H’,’L’, and ‘Ignore’ with each tap. The picture to the right of this button shows
what the controller is currently seeing on that input. Press the yellow [<<] button at the top and
save changes if desired.
• REMOTE HALT: From the ‘Run Tool’ Screen:
o Tap the ‘Setup’ Button
o Make sure the task shown at the top is the one to be programmed.
o Tap the ‘Inputs’ Button
o Tap the arrow button on the bottom next to ‘Setup Bolt(s)’ so that ‘Setup Misc’ appears.
Highlight
Highlight
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
http://www.hmcelectronics.com
(800) 482-4440