Brother HL-1660E - Manual (Page 72)

CHAPTER 4 CONTROL PANEL
4–5
SWITCHES IN NORMAL MODE
You can control the basic printer operations and change various printer
settings in the NORMAL mode. Functions available in the NORMAL
mode are shown above the panel switches.
Fig. 4-3 Switches in NORMAL Mode
✒ Note
The factory settings are printed in bold in this section.
SEL Switch
Pressing the SEL switch changes the state of the printer between on-line
and off-line. When the printer is on-line, the ON LINE lamp lights and the
printer is ready to receive data from the computer. When the printer is off-
line, the ON LINE lamp is off.
To receive data from the computer, set the printer on-line. To operate the
control panel switches, set the printer off-line.
When you press the SEL switch when the printer is the on-line state, it
turns off-line and the LCD displays the current emulation mode.
AUTO LaserJet 5
You can enter other emulations in the auto emulation mode by pressing
the ▲ (UP) or ▼ (DOWN) switch.