beautypg.com

Reloading factory default settings, 5 reloading factory default settings – GeoDesy Gigabit 1200 Auto Tracking link series User Manual

Page 40

background image

40

GeoDesy Kft.

Telefon: 06-1-481-2050

H-1116 Budapest, Kondorfa str. 6-8.

Fax.: 06-1-481-2049

E-mail: [email protected]

http://www.geodesy.hu

9.5 Reloading factory default settings


Should you need to reload the original factory settings follow the steps below.

1. turn ON the switch of Power Adapter
2. wait 3 seconds
3. then turn OFF the switch of the Power Adapter
4. above procedure 3 times.
5. plug turn ON the Power Adapter an leave it turned ON

After this the system resets the following information to the factory default.

- IP address
- Username
- Password
- Device name
- SNMP settings
- Alerts
- Auto MDI/MDIX

-

NPASD (if avialable):

if the reciver does not detect sufficient light power, then

in the head would switch off the network connection signal. Note: During this
perid the 100MB/s laser heads MGM will not be available.