Garland MO QU 28000 FL INDUCTION MODULE-LINE COOKTOPS DUAL/QUAD - Manual (Page 26)

Installation RTCSmp Built-In Module-Line Dual/Quad Cooktops
26 Part # 4532415 Rev 3 (8/19/14)
C. NOTE: BEFORE applying any silicone adhesive, CLEAN glass, silicone gaskets, frame, and tops with
isopropyl alcohol or equivalent.
Apply a line of silicone adhesive PACTAN onto the bracket before placing the silicone gaskets/stripes
(provided). After placing the silicone stripe onto the bracket, apply silicone adhesive on top of the
silicone stripe. PACTAN is not provided (part number = 70000015).
D. Examine the Ceran glass before installation.
i. Then carefully lower the glass onto the silicone stripe.
NOTE: When installing multiple glass-tops side by side, ensure to orient all the logos on the
glass-tops the same direction.
ii. Align the edges of the glass with the edges of the countertop cut-out.
E. Level the glass by adjusting the screws.
F. To provide a water tight seal, apply silicone sealant completely around, filling any gaps between the
glass and the counter-top surface.
IMPORTANT Let the silicone adhesive to cure properly before installing the coil carrier sheet.
To install the coil carrier sheet:
NOTE: Before installation, check the kitchen plan and coil layout (orientation) to ensure the side with the plug
connectors on the coil sheet is oriented correctly for wiring and service.
G. Loosen the two screws to free the retaining rails. The rails are hinged at the hooks at the back.
C
D
E
F
min 1.5 [0.06]