Gamber-Johnson 7160-0354 - Manual (Page 3)

LOW FREQUENCY ANTENEA
4. Install the low frequency antenea onto the YAW Sensor Plate using the provided
nylock nuts and #6-32 x 3/8 screws.
5. Connect the harness between the LFA, USB/MP3 box and 12v jack if used.
6. Place Spacer Bushings over rear studs on the transmission tunnel.
7. OPTIONAL Remove knockout on lower right hand side of the box and install
provided 12V jack. Install ground and power as required.
8. Slide console into vehicle. Downward pressure may be required on the front of the
box to allow it to slide under the instrument panel.
9. Secure console with OEM nut and provided M6 nuts, washers and lock washers on
front two brackets and provided 1/4-14 x 1.0" sheet metal screws at rear
attachement points. Some of the vinyl flooring may need to be cut to reveal the
rear mounting points.
10. Install the armrest (7160-0327, 7160-0347 & 7160-0354) into the tube and adjust to
desired height/orientation then tighten the bolt under the armrest. Note
Armrest is not included with 7160-0326 or 7160-0353 but can be ordered
seperately.
11. The cup holder (7160-0327) can be placed anywhere along the horizontal length
of the box. Note cup holder is not included with 7160-0326 or 7160-0353 but can
be ordered seperately.
12. Once the console box is secure, drive a self tapping screw (provided in hardware
bag) through the hole in the dash filler panels to secure them to the instrument
panel. Note Be careful not to over tighten the self tapping screw.
13. If required, the Top Plate and the Center Brace can be removed to allow easier
access for mounting and/or cable routing. If either item is removed Gamber-
Johnson recommends reinstalling the flat head screws with a drop of Blue 242
Loctite to prevent loosening.