Gamber-Johnson 7160-0354 - Manual

Rev.G INST-516
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
#6-32 PAN HEAD SCREWS
REMOVE FOR SERVICE
REAR STUDS FRONT STUDS
AND ANGLE ADJUSTMENT
ARMREST HEIGHT
SPACER BUSHING
REAR MOUNTING
POINTS
#6 SELF DRILLING
SCREW
DASH FILL EXTENSION
Revision
PS-001
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Printing Spec:
7160-0326, 7160-0327, 7160-0353, 7160-0354, 7160-0347
INSTALLATION INSTRUCTIONS
Product
Description - Charger Console 2011+
Form
1. Before installing console into vehicle, unpack and install the Dash Fill Extensions
(one per side) to the console box using the provided #6-32 nylock nuts (3 per side).
2. Remove factory console and/or top plate from vehicle.
3. Disconnect the factory harness and remove the low frequency antenea (LFA) from
the stock plastic center console.
© Copyright 2012 Gamber-Johnson, LLC