Gamber-Johnson 7160-0275 - Manual

Plate, Universal Display Mount
INSTALLATION INSTRUCTIONS
Product Revision Form
7160-0275 Rev.C INST-495
Printing Spec: PS-001
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
© copyright 2010 Gamber-Johnson, LLC
The Universal Display Mount Plate attaches to the Universal Display Mount (7160-0272,
7160-0273). Refer to the installation instructions for the Universal Display Mount for
additional installation instructions.
The Universal Display Mount Plate accepts displays with the following mounting patterns:
- 75mm VESA
- Motorola MW800/MW810
- 100mm VESA - Gamber Johnson 4.09"X2.00" Accessories
- Data911 Displays (15.0" & 12.1") with 7160-0302
Installation:
1. Install the display to the Plate using manufacturer recommended hardware.
a. The plate can be installed forward, backwards or upside down depending on
mounting requirements.
2. Using the supplied 1/4-20 hardware, install the plate into the slots in the Universal Display
Mount. Per the picture below, the Plate can be installed using either set of mounting holes
3. The plate can be installed using either the upper or lower set of holes depending on the
desired final mounting position.
VESA 75mm
VESA 100mm
GAMBER
4.02" X 2"
MOTOROLA
MW800/810
1/4-20 UNC
HARDWARE
ROBOVU ROBOVU
ROBOVU FAN
CLEARANCE