Gamber-Johnson 7160-0505-xx - Manual (Page 3)

Figure 4
Figure 3
Sliding Door
Figure 2
Latch
Page 3 of 5
Inserting the computer into Docking Station
Make sure the Sliding Door (located on 1.
the underside of the computer) has
been opened, exposing the computer's
docking connector. (see Figure 2)
Make sure that the docking station Latch 2.
is in the open positon before inserting
computer. With the computer held at an
angle insert the front edge of the handle
under the front tabs. (see Figure 3).
Finish by setting the back of the 3.
computer onto the dock so that it is flat.
Press the latch until it is fully engaged
and remains closed. (see Figure 4)
To remove computer make sure 4.
computer is turned off and reverse
procedure above.