beautypg.com

Inserting computer into the dock – Gamber-Johnson 7160-0470-xx User Manual

Page 4

background image

INSERTING COMPUTER into the DOCK

Make sure the sliding door (located on

1.

the backside of the computer) has been
opened, exposing the computer's
docking connector. (see Figure 3)

Disengage over center latches, one on

2.

each side of the dock to allow for them
to separate from the hooks that hold
down the top catch. Rotate top catch
up and then back to allow room for the
computer to be inserted. (see Figure 4).

Insert bottom edge of the computer into

3.

the dock at an angle so that the hooks
on the dock can be nested into the
recessed areas located on the front
lower portion of the computer. (see
Figure 5. Rotate computer backwards
into the dock until fully seated in the
dock. Rotate top catch forward and
down onto the computer and re-engage
over center latches to secure computer
in the dock.

To remove computer make sure

4.

computer is turned off and reverse
procedure above.

Figure 3

Figure 4

Figure 5