Flint & Walling Centrifugal Packages - CJ103 - Manual

1
95 North Oak Street • Kendallville, IN 46755 • Copyright © 2010. All rights reserved.
GENERAL SAFETY INFORMATION
1. Follow all local electrical and safety codes, as
well as the National Electrical Code (NEC) and
the Occupational Safety and Health Act (OSHA).
2. Replace damaged or worn wiring cord
immediately.
3. Do not kink power cable and never allow the
cable to come in contact with oil, grease, hot
surfaces or chemicals.
4. Protect the power cable from coming in contact
with sharp objects.
5. Be careful when touching the exterior of an
operating motor - it may be hot enough to be
painful or cause injury.
6. Make certain that the power source conforms
to the requirements of your equipment.
7. Always disconnect power source before
performing any work on or near the motor or
its connected load. If the power disconnect
point is out-of-sight, lock it in the open position
and tag it to prevent unexpected application
of power. Failure to do so could result in fatal
electrical shock.
8. Do not handle the pump with wet hands or
when standing in water as fatal electrical shock
could occur. Disconnect main power before
handling unit for ANY REASON!
9. Unit must be securely and adequately
electrically grounded. This can be
accomplished by wiring the unit to a ground
metal-clad raceway system or by using a
separate ground wire connected to the bare
metal of the motor frame or other suitable
means.
10. Risk of electric shock. This
pump has not been investigated for use in
swimming pool areas.
11. This product contains
chemicals known to the State of California
to cause cancer and birth defects or other
reproductive harm.
NOTE: Pumps with the “CSA” mark are tested to
UL standard UL778 and certified to CSA standard
C22.2 No. 108.
OWNERS GUIDE TO INSTALLATION
AND OPERATION
READ THESE INSTRUCTIONS CAREFULLY
Read these installation instructions in detail before installing your pump. Be sure to check the
following:
1. Be certain the motor is connected for the correct line voltage being used (check motor
nameplate).
2. Be certain the pump is completely primed before starting. Otherwise damage may occur to the
seal.
Every pump is tested before leaving the factory, and its performance depends largely on the
installation.
END SUCTION CENTRIFUGAL PUMPS
IL0412
IL0201
Figure 2 - CJ101 Series Figure 1 - CJ103 Series
130441
FW0078
0310
Supersedes
0110
Drain Plug