beautypg.com

Flint & Walling Artesian Drive Controllers - AD150145 User Manual

Centrifugal constant pressure control

background image

1

(FW1086)

95 North Oak St. • Kendallville, IN 46755 • 1-800-345-9422

Centrifugal Constant
Pressure Control

Models AD052045, AD070059,
AD096074, AD096096, AD150145

Operating Instructions & Parts Manual

Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product
described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal
injury and/or property damage! Retain instructions for future reference.

FW1086

0411

Supersedes

0809

Descriptions and Features

The F&W Artesian Drive is a dependable water system
Variable Frequency Drive (VFD) that uses custom program-
ming to enhance the performance of standard centrifugal
pumps. When applied correctly to three phase motor driven
pumps, the Artesian Drive eliminates pressure cycling associat-
ed with conventional pressure switch controlled water pump-
ing systems and provides a constant output pressure.
Key FeAtures OF the ArtesIAn DrIve InCluDe:

Constant water pressure with a wide range of settings
(30-80 psi) (Note: The maximum obtainable system pres-
sure is limited by the performance of the pump installed)

Smaller pressure tank can be used

Fits the pump to the application – pump speed is con-
trolled to provide the optimum performance without
overloading the motor

Flexibility – you can use this unit with standard off-the-
shelf pumps and 3-Phase motors

No in-rush (power-on transient) current

Low motor start-up current (soft-starting)

Active Power Factor Correction minimizes input RMS cur-
rent

Protection features

-

Dry run conditions – using intelligent load monitor-
ing (see Page 8)

-

Bound pump – with auto-reversing torque

-

High voltage / lightning surge

-

Low line voltage

-

Short circuit

unpacking

When unpacking the unit, inspect carefully for any damage
that may have occurred during transit.

Included Items:

A. Controller Unit

F. Wiring Enclosure

B. Strain Relief Fittings
* Only one fitting w/

AD150145

G. Memory Stick &
Retainer

C. Pressure Sensor and Boot H. Warranty Card
D. Sensor Adjustment Tools

I. Installation Guide

E. Sensor Cable

J. Installation Manual

B

C

A

E

D

J

H

F

I

G

IL0736

Figure 1

General safety Information

Carefully read and follow all safety instructions in this
manual and on pump. Keep safety labels in good condi-
tion. Replace missing or damaged safety labels.

This is a SAFETY ALERT SYMBOL. When you see

this symbol on the pump or in the manual, look for one of
the following signal words and be alert to the potential for
personal injury or property damage.

Warns of hazards that WILL cause serious

personal injury, death or major property damage if ignored.

!

Warns of hazards that CAN cause serious

personal injury or death, if ignored.

Warns of hazards that MAY cause minor

personal injury, product or property damage if ignored.
IMPORTANT: Indicates factors concerned with operation,
installation, assembly or maintenance which could result in
damage to the machine or equipment if ignored.
NOTE: Indicates special instructions which are important but
are not related to hazards.

022687