Barco DCS-200 - Manual (Page 83)

DCS-200 • User’s Guide 83
4. Operation
Using the Setup Menu
• Press SEL to reset the system.
• Press ESC to cancel the operation, and return to the Setup Menu.
The following attributes constitute a “factory default” condition:
• Input 1 is on Program.
• The Output is set to [email protected].
• The Output Raster Box is OFF .
• The Status Menu is displayed.
• All menu items are set to their default values (as specified in this chapter).
• The serial port is set to the following default values:
~ Baud: 115200
~ Parameters: N81 (No Parity, 8 Data Bits, 1 Stop Bit)
~ Handshaking: OFF