Barco DCS-200 - Manual (Page 74)

74 DCS-200 • User’s Guide
4. Operation
Using the Setup Menu
• Default : 10
bíÜÉêåÉí
From the System Menu, select Ethernet to display the Ethernet Menu:
Figure 4-41. Ethernet Menu (sample)
The following Ethernet functions are available:
• DHCP — DHCP can be turned OFF or ON .
~ When OFF , the Config Network field appears, which enables you to
manually enter a static IP address, Subnet mask and Gateway.
~ When ON , the DCS-200 queries the DHCP server for a valid IP address,
and the Config Network field is hidden.
• If the DCS-200 finds a DHCP server and receives an IP
address, the address is displayed.
• If a server is not found, an IP address is not assigned.
• Config Network — select this function to display the Config Network Menu,
which enables you to choose the specific Ethernet address you wish to change.
Figure 4-42. Config Network Menu (sample)
Note It is recommend that you use a low intensity setting to avoid
"burn-in" of the display.
E T H E R N E T
> D H C P
O F F
C o n f i g N e t w o r k > >
I P 1 9 2 . 16 8 . 0 0 0. 0 1 0
M 0 0 : 0 4 : a 5 : 1 9 : 1 0 : 5 2
Note Always consult with your network administrator to obtain valid
IP, subnet mask and gateway addresses.
C O N F I G N E T W O R K
> S e t S t a t i c I P
> >
S e t N e t m a s k > >
S e t G a t e w a y > >