User preference, In auto acquire, Rëéê=mêéñéêéååé – Barco DCS-200 User Manual
Page 70
70
DCS-200 • User’s Guide
4. Operation
Using the Setup Menu
rëÉê=mêÉÑÉêÉåÅÉ
From the Setup Menu, select User Preference to display the User Preference Menu:
Figure 4-39. User Preference Menu (sample)
The following functions are available:
•
•
•
•
•
•
•
fе=^мнз=^ЕимбкЙ
The In Auto Acquire function enables or disables the Input Auto Acquire mode, which
acquires a signal for the input. Values for In Auto Acquire are:
OFF
and
ON
(default).
When In Auto Acquire is
ON
, and an input has a saved configuration file, the system
attempts to use the saved file. If the input timing matches the timing in the saved
configuration file, the saved file is used.
The system always performs a full sync (timing) acquisition on the selected input signal
under the following conditions:
•
When an input without a saved configuration file is selected
•
When the input type is changed
•
When the input signal’s sync rate is changed
•
When an input with a saved configuration file is selected, but the input timing is
different from the saved configuration
When In Auto Acquire is
ON
, and the input source is non-digital, the system uses the
following library search order:
•
Saved configuration files defined in the File Association Menu for each input
channel
•
The user’s library of saved files
•
The standard Input Format table defined in Appendix A, in the “
”
section on page 122
•
A best guess
U S E R P R E F E R E N C E
> I n A u t o A c q u i r e
O N
A u t o I n p u t C f g .
O F F
A u t o I n p u t S a v e
O N
B l a c k A u t o T a k e
O F F
K e y A u t o T a k e
O F F
M e n u C o n t e x t
O F F