ETC Source Four CE jr and jr Zoom Assembly Guide - Manual (Page 15)

CE Source Four jr / jr Zoom Assembly Guide 15
Final assembly
Tools required: Phillips head screwdriver.
1. Place the left barrel casting (1) face up on your work surface with
the colorframe end to your right.
2. If necessary, place spring (17) over post in right and left castings
(1 and 2). Secure with the push-on retainer (18).
3. Set shutter assembly into the shutter slot in left casting (1) with
the rounded side of the shutter handles facing right.
4. Install the short end of the gel retainer clip (5) in the left lens
holder casting (1).
5. Position clip (5) in the forward, locked position, then install the
retainer spring (8) on the clip.
6. Snap spring (7) onto reflector (6) and place assembly into left
casting (1) so that the front edge of the reflector is supported by
spring (17) and the spring (7) on the back rests in the left casting
rear supports.
7. Gently set the right barrel casting (2) onto the left casting so that
the gel clip retainer, shutter assembly and reflector assembly fit
into their respective positions.
8. Starting with the corner nearest the gel clip retainer, attach the
right casting to the left casting with screws (22). Do the right
screws first, then the middle screws, then the left screws.
9. Install the iris slot cover (20) onto the barrel assembly with
screws (21).
10. With the colored dot on the lens facing out the barrel, slide the
lens holder assembly (or assemblies, if Zoom) into the lens
holder track inside the barrel. The assembly should slide
smoothly in the track.
11. Insert light baffle strip (19) through front of barrel assembly and
through hole in lens holder assembly. Slide strip (19) through
supports in front of fixture and install screw (15), spring (27),
washer (26), and knob (4).
12. Attach the lamp burner (3) to the barrel assembly with the
knurled head screw.
13. Attach yoke (10) to barrel assembly with bolts (12) and washers
(14). Attach yoke knob (11) with bolt (13) and washer (14).
Tighten bolts (12) to secure yoke to fixture.
Note: Left and right designations are
your left and right as you look at the
front (gel plane) of the unit.