ETC Source Four CE jr and jr Zoom Assembly Guide - Manual (Page 13)

CE Source Four jr / jr Zoom Assembly Guide 13
Shutter assembly
Tools required: None
1. Place the bottom divider plate (2) on a flat surface.
Note: The notches on the divider plates must line up with each
other.
Warning: Divider plate edges are sharp. Handle with caution!
2. Place two shutter blades (1) on top of plate (2), handles facing
outward.
Note: Install shutter blades with the rounded sides facing the
same direction.
3. Place the middle divider plate (3) on top of the two shutter
blades.
4. Place the two remaining shutter blades (1) on top of the middle
divider plate.
Note: The third and fourth shutter blades should be at 90˚ angles
to the first and second.
5. Place the top divider plate (4) on top of the third and fourth
shutter blades.
6. Install the four springs (6) onto the nips on the spring plate
support (5).
7. Place the dimples of the plate divider (4) onto the open ends of
the springs.
Figure 12
Figure 11
1
3
2
6
5
4