ETC Source Four Revolution User Manual

Page 30

Source Four Revolution User Manual

Step 3:

When the attachment tab on the left spool is revealed at the end of the leader,

release the tab from the attachment point.

Step 4:

Carefully roll up the gel string. When the gel string is rolled up, the trailer

attachment point on the right spool is revealed.

Step 5:

Detach trailer from the right spool and remove the gel string.

Step 6:

Attach the replacement gel string’s trailer to the right spool by feeding the

attachment tab down through the bar/slot and around onto the attachment point.

Step 7:

Roll the gel string tightly onto the right spool. Leave enough of the scroll unrolled

to allow you to attach the leader to the left spool. Keep tension on the scroll.

Step 8:

With your other hand, while placing your thumb on the bar and slot portion of the

left spool, spin the spool away from the center of the cartridge until the

attachment point is facing up. Then spin the spool as listed on the spring tension

label (located on the left spool) to generate the proper tension in the spring.

Continue spinning the spool about 1/4 turn until the bar/slot is visible and facing

the center of the scroller cartridge, as shown above.

Step 9:

Feed the end of the leader up through the bar/slot and over onto the attachment

point.

Step 10: When the leader is attached to the left spool, let go of the spools. The gel scroll

should spool a number of frames onto the left spool and then settle.

Step 11: Reset the fixture to calibrate and ensure proper performance of the scroller.

GEL TENSION

DIRECTION OF DRUM ROTATION

GEL TENSION

DIRECTION OF DRUM ROTATION

Trailer

Attachment

Leader

Attachment

To tension the scroller

Leader shown

Rear View

Spring Tension

Label

Left spool

Right spool