Routine maintenance – ETC Source Four Revolution User Manual

Page 27

Routine Maintenance

To ensure optimum performance of your Source Four Revolution fixture, you should

perform the following inspections and cleanings at least once a year. You may need to

inspect or clean the fixture more often, depending on the type and amount of use your

fixture experiences during the year.

C A U T I O N :

NEVER spray liquids into the fixture.

NEVER spray compressed air into a fixture that is powered-up.

ALWAYS remove the lamp prior to cleaning the reflector.

Open the fixture and clean out any dust and debris. All components can be cleaned

using compressed, oil-free air or a soft, lint-free cloth. No liquids of any type should be

used to clean the interior of the fixture.

Inspect all modules for wear and, if necessary, clean using compressed, oil-free air or

a soft, lint-free cloth.

Power up the unit with the covers removed and watch for all of the components to

move freely upon fixture calibration.

Inspect gel string for wear and replace as needed. See

Inspect Internal Media Frame media and replace as needed. See

Inspect gobos for wear and cracking. Replace as needed.

Inspect both lenses and the reflector for cleanliness.

To clean the lenses, dampen a soft, lint-free cloth with vinegar or household ammonia

and gently wipe each lens surface.

To clean the reflector, remove the lamp, dampen a soft, lint-free cloth with alcohol or

distilled water and gently wipe the reflector.

Adjust the tension of the various belt drive mechanisms. See

W A R N I N G :

Regularly check to make sure all modules are fully seated in the module

bays. Also ensure that the module thumbscrews are fully finger-tightened.