Connections and addressing, N o t e – ETC Source Four Revolution User Manual
Page 12
8
Source Four Revolution User Manual
Connections and Addressing
Connect AC input power and DMX data cables to the appropriate ports as shown below.
Connect the incoming DMX data cable to the DMX Input connector. If you are daisy-
chaining the data to other fixtures or DMX-controlled devices, connect the next DMX cable
to the DMX Thru connector. Revolutions built prior to 2007 (Part Number 7160A1002)
require that the last fixture on a DMX line be terminated with a 100
Ω resistor between pins
2 and 3. Revolutions built in 2007 or after are self-terminating and do not require
termination. If both types are used on the same DMX line, it is recommended that the line
be terminated.
Use the three thumbwheels on the upper enclosure to set the starting address for the
fixture. Addresses must be set between 1-481. The fixture will report an error if the address
is set to 482 or above. See
, for channel mapping.
N o t e :
Revolution is a 31-channel fixture. A fixture with a starting address higher than 481 will
not have control of all parameters.
Connect the AC Input cable:
Align and insert the power connector. Twist the connector clockwise until it locks into place.
Disconnect the AC Input cable:
Slide back the locking tab, twist the connector counterclockwise and pull to unlock and
disconnect the power connector.
I
O
I
O
1 2
3
4
5 6
7
8
9
1 2
3
4
5 6
7
8
9
1 2
3
4
5 6
7
8
9
1
2
3
4
5 6
7
8
1
2
3
4
5 6
7
8
1 2
3
4
5 6
7
8
AC Input
(Neutrik
®
PowerCon
®
connector)
Power Switch and
Breaker
DMX Input
DMX Thru
Thumbwheels
Front Bay
Rear Bay
Tilt Lock
Pan Lock
LEDs