ElmoMC SimplIQ Analog Servo Amplifiers-Cymbal - Manual (Page 28)

Cymbal Installation Guide Installation
MAN-CYMIG (Ver. 1.3)
28
3.5.3.2. J4 Hall’s Signal Port
Port J4 is a 15‐pin D‐Sub female connector. When assembling this cable, follow the instructions
in Section 3.5.2 Control, I/Os and Halls Cable Assemblies using a 15‐pin a metal case D‐Sub
male connector (plug).
Pin Signal Function Description Pin Position
1 HALL+15V +15 V Hall supply
voltage:15 V ± 10%
at 30 mA
+15 V supply voltage
for Hall sensors.
Output current:
maximum of 30 mA.
15‐Pin Female
2 HALL+ 5V +5 V Hall supply
voltage: 5 V ± 10% at
30 mA
+5 V supply voltage
for Hall sensors.
Output current:
maximum of 30 mA.
3 HARET Hall supply voltage
return Return used only for
Hall supply.
4 HARET Hall supply voltage
return Return used only for
Hall supply.
5 HA Hall A input
Logic levels: TTL
Maximum input
voltage: 15 VDC.
6 HB Hall B input
Logic levels: TTL
Maximum input
voltage: 15 VDC.
7 HC Hall C input
Logic levels: TTL
Maximum input
voltage: 15 VDC.
8 N.C.
9 N.C.
10 N.C.
11 N.C.
12 N.C.
13 N.C.
14 N.C.
15 N.C.
J4 Female
Table 9: J4 Halls Cable ‐ Pin Assignments
www.elmomc.com