ElmoMC SimplIQ Digital Servo Drives-Bell Installation Guide User Manual
Page 6

Bell Installation Guide
Safety Information
MAN-BELIG Ver. 1.302
6
3.11.1. Digital Input ................................................................................................... 35
3.11.2. Digital Output ................................................................................................ 37
3.11.3. Analog Input .................................................................................................. 38
3.12.1. RS-232 Communication ................................................................................. 39
3.12.2. CAN Communication ..................................................................................... 40
3.15.1. Bell Thermal Data .......................................................................................... 42
3.15.2. Heat Dissipation Data .................................................................................... 42
3.15.3. How to Use the Charts ................................................................................... 43
4.2. Power Ratings ............................................................................................................... 46
4.3. Environmental Conditions ............................................................................................ 47
4.4.1. Current Loop .................................................................................................. 48
4.4.2. Velocity Loop ................................................................................................. 49
4.4.3. Position Loop ................................................................................................. 49
4.5.2.1. Incremental Encoder Input ........................................................... 50
4.5.2.2. Digital Halls ................................................................................... 51
4.5.2.3. Interpolated Analog Encoder (Sine/Cosine) ................................. 51
4.5.3. Auxiliary Feedback Port (input mode YA[4]= 2, 0) ........................................ 52
4.6.1. Digital Input Interfaces .................................................................................. 53
4.6.2. Digital Output Interface ................................................................................. 54
4.6.3. Analog Input .................................................................................................. 54
4.7. Communications ........................................................................................................... 55
4.8. Pulse Width Modulation (PWM) .................................................................................. 55
4.9. Standards Compliance .................................................................................................. 56