Elkhart Brass Sidewinder 7161 EXM UHP - Manual (Page 21)

EXM UHP– Operating Instructions
21
K. Write Diagnostic File
 Remove the USB cover from any input controller.
 Install a blank USB flash drive into the USB port of the desired input controller, and the controller will
automatically enter Programming Mode (If Update Mode does not initiate, hold AUX and OSCILLATE
for 2 seconds)
o The yellow status LED on controller will begin to blink once per second
o If using Joystick, all valve LEDs will flash once to indicate that you are in Programming Mode
 Press and release the OPEN button
 A diagnostic file called EBDIAG.CSV is written to the USB flash drive
 Remove the USB from the input controller to leave Programming Mode
 Contact Elkhart Brass to make arrangements to send the EBDIAG.CSV file for review.
L. Update Firmware
 Before updating firmware ensure that all components intended for the update are powered up and
connected to the chosen input controller through either the CAN string.
 Remove the USB cover from any input controller.
o Although any input controller may be used for updating firmware, it is suggested that a controller
connected via the CAN string is used, if available.
 Install the USB flash drive with the newest firmware version into the USB port of the desired input
controller, and the controller will automatically enter Programming Mode (If Update Mode does not
initiate, hold AUX and OSCILLATE for 2 seconds)
o The yellow status LED on controller will begin to blink at once per second
o If using Joystick, all valve LEDs will flash once to indicate that you are in Update Mode
 Press and release the PRESET button
 The input controller will read the hex file on the flash drive and install it as long as the copied firmware is
newer than the existing firmware.
o This process will likely take up to ten minutes to complete.
o This action will also update all input controllers on the CAN bus (primary and secondary)