Eberspacher EasyStart R - Manual (Page 7)

7
Flashing symbols
Each flashing symbol
in the menu, program
and display bar can be
changed with or
and confirmed with .
Basic operation and adjustment rules
Activate mobile unit
Before each operation or setting, a con-
nection must be established between the
mobile unit and the stationary unit.
To do this, press until the menu bar
appears in the display, then release the
key and continue with the operation or
adjustment (see also page 8).
Switch off mobile unit / protect mo-
bile unit against involuntary actuation
If is pressed for a long time the
display disappears, i.e. the mobile unit
is switched off and is therefore also pro-
tected against involuntary actuation.
Confirm input
The settings and changes must always
be confirmed with , otherwise they are
lost (exception: operating time).
Terminate/quit settings
You can use to terminate or quit
entering settings in a menu.
Set operating time
(one-off or permanent)
The operating time can be individually set
with or .
In preset mode from 10 – 120 minutes.
In immediate operation from 10 – 120
minutes or continuous operation .
See pages 9, 10, 12 and 14 for a descrip-
tion.
Display disappears
If a setting/adjustment or confirmation is
not made within 10 seconds the display
disappears, i.e. the mobile unit returns to
its normal condition.
For renewed input you must press
again.
Display during data transmission
During data transmission
(display SENd) the LED
display lighting switches
off.
After the data transmission has finished
the LED lighting is switched back on.
Operation and Adjustment