Eberspacher EasyStart Timer Operating instructions - Manual (Page 29)

VehiCLe heATeRs – TeChniCAL DOCuMenTATiOn | 29
4 WhAT TO DO iF …?
iN thE EVENt Of a fault thE fOllOwiNg displays arE pOssiBlE:
DispLAy DesCRipTiOn ReMeDy / CusTOMeR
INIT
ƒ Automatic detection is active.
ƒ The easystart Timer has been dis-
connected from the power supply
and then reconnected.
Wait until the automatic detection has
finished, then set the time and weekday.
NO SIGNAL
ƒ no communication. Check and if necessary renew the heater
fuse.
Visit your vehicle workshop.
Error
ƒ 1st heater fault. Visit your vehicle workshop.
Error
ƒ 2nd heater fault. Visit your vehicle workshop.
ƒ Voltage too low. Charge battery, if necessary visit your
vehicle workshop.
18:30  °C
ƒ Temperature sensor is defective Visit your vehicle workshop.
plEasE NOtE!
if you are unable to remedy the error or fault, please
contact an authorised je workshop or dial the follow-
ing service phone number.