Eberspacher EasyStart Timer Operating instructions - Manual (Page 20)

20 | VehiCLe heATeRs – TeChniCAL DOCuMenTATiOn
BittE BEachtEN!
if the symbol is not displayed in the Menu bar, the
heater is in ADR mode; preselected heating mode is
not possible here.
When programming the easystart Timer, note the
operating mode as described in the following.
DepARTuRe TiMe OpeRATing MODe (FACTORy
seTTing)
under the following conditions the preselected heat-
ing mode is not started on the current day.
ƒ The current day and the preselected day are iden-
tical.
ƒ The current time lies within the time period, depar-
ture time minus operating time.
example:
Current day / preselected day: Thu
Current time: 18:45
Departure time: 19:00
Operating time: 30 minutes
Duration: 18:30 to 19:00
The current time lies within the time period, the
heater is not switched on.
The program will be run during the next week.
sTART TiMe OpeRATing MODe
in start Time operating mode the heater is started
on the preselected day and when the set time is
reached.
3 OpeRATiOn AnD seTTing/ADjusTMenT
gENEral iNfOrmatiON ON prOgrammiNg thE
prEsEt timE
The programming of the preset time is carried out in
menu item .
The easystart Timer can be used to program 3 preset
times. The 3 preset times can either all take place on
one weekday or can be distributed between different
weekdays.
3 weekday ranges are available to choose from,
these can each be started daily with a preset time.
Weekday ranges:
sat – sun
2x heATing / VenTiLATiOn
Mon – Fri 5x heATing / VenTiLATiOn
Mon – sun 7x heATing / VenTiLATiOn
if the system is activated with programmed weekday
range, all weekdays are worked through consecu-
tively; after that renewed programming is required.
example:
if the easystart Timer with a programmed weekday
range Mon – Fri is activated on sunday, the heater
heats or ventilates from Monday to Friday with the
set defaults (5x heATing / VenTiLATiOn).
if the easystart Timer with a programmed week-
day range Mon – Fri is activated on Wednesday, the
heater heats or ventilates on Thursday and Friday, the
heater is not operated on saturday and sunday. From
Monday to Wednesday of the following week the
operation is continued with the set defaults
(5x heATing / VenTiLATiOn).
After a weekday range has been worked through
renewed programming is required.