Despatch 1500 Controller - Manual (Page 31)

Despatch/Watlow 1500 Control Instruction Manual Page 25
Procedure for Programming HAST Profile
1. If power on, check HALT LED. If off, press RUN/HALT.
2. Press RESTART.
3. Press MODE until CHG PARA LED is lit.
4. Press FCTN until FUNCTION display reads GA.
5. Press UP arrow until DATA display stops at 2000.
6. Press DOWN arrow until display reads 1995, press
enter key.
7. At Step 1 the display will read 01 SP (if Step 1 is clear),
press enter.
S1 is displayed, use arrow keys to 20, press enter
S2 is displayed, use arrow keys to 70, press enter
E1 is displayed, use arrow keys to 0000, press enter
E2 is displayed, use arrow keys to 0001, press enter
HR is displayed, use arrow keys to 00, press enter
MN is displayed, use arrow keys to 00, press enter
SC is displayed, use arrow keys to 05, press enter
TIME is displayed (this displays the HR MN SC for
what was just programmed)
NX is displayed, use arrow keys to 0002, press enter
8. At Step 2 the display will read 02 SP, press FCTN until
WT appears (if S1 is displayed, press “CLEAR” and it
will read SP), press enter.
Press FCTN until W3 is displayed, use arrow keys to
0001, press enter
Press FCTN until NX is displayed, use arrow keys to
0003, press enter